Click here for full size photo (364K)
| This view shows the
main switch panel and the avionics stack beneath it. The PS Engineering
intercom is mounted on the right side of the stack using Velcro and tie
wraps for easy removal if desired. Interfaces for the noise-canceling Bose
headsets are mounted above and to the right of the switch panel. One headset
is currently plugged in. The PS intercom plugs into the stock Eagle intercom
system at the far right side where the red and black plugs are visible.
If the PS intercom fails or is removed, the stock intercom is still intact. For
intercom details go to www.ps-engineering.com/pm1000ii.shtml
The digital voltmeter/ammeter is mounted beneath the transponder and may be moved to the front panel. Volts and amps are displayed digitally in tenths which is more accurate than the standard needle unit which is still mounted next to the main switches. An oversized rudder ball is mounted on the canopy support cross-brace. This can be handy when an oversized passenger (been-there, done-that) blocks the rudder ball from view on the front panel. The Lexan floor is visible below the side floorboards. A wire harness runs to the left of the control arm and oil lines for the auxiliary oil cooler are visible to the right. |
